Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

I have recently installed an la 481 loader on my 2wd L2900 Kubota. My only complaint has been that when the bucket is full, and the ground is wet my 5.00-15 tri ribs on the front sink. I am thinking of putting wide turf tires on the front to add floatation and footprint for wet ground. any insight as to how much difference this makes, and where I can find rims and tires for a reasonable cost. The kubota price for the rims is steep!<br>Thanks<br>Todd

kubota turf tires
Parts and Repair
Replies 1 Post by Todd Barber

I am looking for a 3pt hitch log splitter. anyone know of a used one(any condition)in the Georgia area, or any recommendation on where to buy one new at a good price? thanks Todd

NEED A 3PT LOG SPLITTER
Operating and Attachments
Replies 6 Post by Todd Barber

Can anyone tell me what a JD model 75 loader was designed to fit, and what is the approx value of a this unit with mounts<br>Thanks <br>TODD

JD MODEL 75 LOADER FIT AND VALUE
Loaders Back Hoes
Replies 4 Post by Todd Barber

can anyone tell me if a john deere loader can be modified or if a kit is available to use it on a kubota L2900? Todd

john deere loader on a kubota l2900
Loaders Back Hoes
Replies 5 Post by Todd Barber

I have a 1948 model M JD, it weighs about 2900lbs. in hard ground, it cannot maintain traction with a 20" 20 disk double gang harrow. With the sections split it pulls fine, just takes a double cut. if your 790 is 2wd i'd say don't even try it your tractor is to light. If it is 4wd try the 8 foot it might pull it on your ground. anyhow, the worst thing that happens is the tractor tires spin and the disk is stuck in the field. spinning tires BETTER not hurt a new JD, and you can always bring your larger tractor (I assume you have one if you have all those pricey harrows) to rescue your plows

CAN THIS TRACTOR PULL A DISK
John Deere Tractors
Replies 9 Post by Todd Barber

Hey everyone, just wanted to say thanks for all the input. The problem turned out to be simple (as usual) just overlooked. I dropped the carb bowl, and noticed that the fuel flow with the float and needle out was slower than normal. further inspection found the fuel filter screeen inside the fuel inlet elbow was clogged up and simply starving the machine for fuel.
thanks again for all the input
Todd

JD model M skips any ideas why
Parts and Repair
Replies 5 Post by Todd Barber